Black Widow Security BW 2800 Spezifikationen PDF herunterladen (Seite 11)

STEP 17: MOUNTING THE CENTER FUSELAGE POD

❑ Plug the servo leads into your receiver and mount the center fuselage

pod to the center wing panel, using the two longer socket-cap screws

and two washers provided.

STEP 18: INSTALLING THE HATCH COVER

❑ The hatch cover is held in place using two hatch latches - one

centered at the front and one centered at the back. Install them by cutting

a slot through the top of the hatch cover for the

latch handle and drilling a hole for the latch pin

through the plywood support bulkheads. Check

the t for smooth operation, then glue them to

the inside of the hatch cover.

❑ Locate the positions of the latch pins onto the front and rear wing

mounting bulkheads, then drill holes through the bulkheads for the pins

to slide into.

❑ Install the hatch cover and double-check that the hatch latches hold

the hatch cover securely in place.

STEP 19: INSTALLING THE OUTER WING PANELS

❑ Slide one aluminum wing joiner tube into one outer wing panel until

the tube bottoms out.

❑ While holding the wing joiner tube in place, drill a 7/64" diameter hole

through the wing joiner tube, using the predrilled hole in the bottom of

the wing panel as a guide.

 You'll need to plug a Y-Harness between the steering servo and the rudder Y-Harness. Double-check that

the nose gear moves the same direction as both rudders.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Black Widow Security BW 2800 Spezifikationen Seite 11