Black Widow Security BW X-Z Series Technical Information PDF herunterladen (Seite 15)

so the flange is above the Z-bracket and flush with the wall.

3. Carefully slide the cabinet down the wall to engage the flange behind

the Z-bracket. Make sure the flange is fully engaged in the Z-bracket

and level before releasing the cabinet.

4. Using a level, make sure the cabinet is vertically plumb.

5. The bottom of the cabinet can be adjusted closer or farther from the wall

by rotating the bottom securing bracket as needed (see Figure 2.3.)

6. When the cabinet is plumb, rotate the securing bracket so one leg is

pointing straight toward the floor.

7. Mark the bracket hole position on the wall, rotate the bracket away from

the mark and drill a 3/8 inch hole.

8. Locate the expandable anchor in the accessory bag.

9. Remove the screw and flat washer from the anchor.

10. Tap the anchor into the hole until its collar flange is flush with the wall.

11. Rotate the securing bracket back over the anchor and secure it with the

screw and flat washer.

12. Check again to make sure the cabinet is level and plumb. Adjust as nec-

essary.

Mounting the Dart Heads

1. Locate the six cap-head screws on the right side of the cabinet.

2. Remove the two screws form the middle of the cabinet with a 5/32 inch

Allen wrench. Set the screws aside.

3. Loosen the remaining four screws, do not remove.

4. Remove the plastic bag from the right-side dart head assembly.

5. Slide the top dart head bracket slots onto the loosened screws at the

top of the cabinet.

6. Slide the bottom dart head bracket slots onto the loosened screws at the

bottom of the cabinet.

Installation and Assembly

2.5

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 154 155

Keine Kommentare

Black Widow Security BW X-Z Series Technical Information Seite 15